# Talk to an agent by voice

Turn on voice in any agent chat, use push to talk, cut in to correct it, and switch between voice and typing in one conversation.

Typing isn't always handy: you're on the shop floor, your hands are full, or it's simply quicker to ask. Every agent in your workspace can talk with you out loud, with the same tools and the same conversation as when you type.

## Turn voice on

1. Open the agent's chat. The round **mic button** sits by the chat box.
2. **Tap** it once. The button turns red and **Active** shows under it: the mic is open.
3. Talk normally. The agent answers out loud and the chat shows what you both said.
4. Tap the mic again to end voice.

With the mic open you can speak at any time, even while the agent is talking. Speaking over it stops its answer, so you can cut in with "no, the other job" and it picks up from there.

The open mic is never remembered: when you reload the page or come back later, voice is off until you tap the mic again.

## Push to talk

In a noisy place, use the mic like a two-way radio.

1. **Hold** the mic button. A ring fills around it.
2. After about 1.5 seconds you hear a quiet chirp and the label says **Talk**. Keep holding and speak.
3. **Let go** to send. A lower chirp confirms it.

Nothing is sent until the chirp, and a pause while you hold doesn't end your turn. You can also hold **Space** or **Enter** while the mic button is selected.

## Cut in and correct it

Holding the mic while the agent is talking stops it straight away. The chat keeps only the part of its answer you actually heard, marked **(interrupted)**, and the agent knows where it was cut off. Correct it the way you would a colleague mid-sentence: "Stop, I meant last week's invoices."

## One conversation, typed or spoken

- **Same tools.** Whatever the agent can do when you type, it can do by voice: search and read knowledge base articles, look up records, run its module's actions. It still only does what your role allows.
- **Same memory.** What you said by voice is part of the typed conversation, and the other way round. After a typed answer you can turn voice on and say "read me your last answer".
- **Typing while voice is on** sends your typed message into the voice conversation, and the agent answers out loud.

## If it doesn't work

| You see | What to do |
|---|---|
| **Microphone permission denied.** | Your browser blocked the mic. Allow the microphone for this site in the browser (the icon at the left of the address bar), then tap the mic again. |
| **AI isn't set up for your organization yet** | Your workspace has no key for its voice service. A Workspace Admin adds one in **AI providers**, or picks another voice service. See [AI providers: voice for agent chat](article:beee6366-08c9-47f9-9375-fa74f8d5cc77). Everyone else: ask your Workspace Admin. |

## Good to know

- **Which voice you hear** is chosen by your Workspace Admin, for the whole workspace or for one agent. The model picker by the chat box changes typed chat only, not voice.
- **There is no separate Voice page** in System settings or in your profile. Voice is the mic button in the chat; the service behind it is set in **AI providers**.
- **Voice counts toward your workspace's AI usage**, like typed chat.


Source: https://datavisions.ai/docs/everyday-work/talk-to-an-agent-by-voice
